Make a colorful granny square hood with cream seams, a soft face border, and two ties under the chin. Eight matching squares form a flat rectangle. Fold it through the middle and close the back edge to make the hood, then try it on before adding the trim.
Pattern status. This original adult hood pattern was inspired by the supplied image and has yet to be test crocheted. The photos are AI-generated illustrations. Follow the written layout and measure your blocked squares for fit.
Jump to the free crochet pattern ↓
Project Overview
| Detail | Pattern information |
|---|---|
| Skill level | Confident beginner familiar with granny squares and sewing seams |
| Terminology | US crochet terms |
| Construction | Eight granny squares, one folded back seam, single crochet trim, and two chin ties |
| Fit | Adjust the blocked square size using a hood that fits you. Each half of the folded hood measures about two squares high and two squares deep before the trim. |
| Gauge | Use a blocked square as your gauge swatch. All eight squares should match in dimensions and edge stitch counts. |
Materials and Tools
- Worsted-weight yarn in cream for borders, seams, and ties. Gather scraps of the same weight in rose, red, mustard, turquoise, violet, and green for the motifs.
- A 4.5 mm crochet hook as a starting point, locking stitch markers, a blunt tapestry needle, scissors, and a tape measure.
- Optional rustproof pins and a mat for blocking.
Choose a yarn that feels comfortable against your face. For a rough yarn estimate, weigh your first finished square and multiply its weight by eight, then allow extra yarn for the seams, trim, and ties. Keep extra cream available because it appears on every edge.
Choose the Blocked Square Size
Lay a hood that fits you on its side. Measure from the crown to the lower front corner, and from the face edge to the back seam. This pattern makes a side panel with the same height and depth. Pick a square size equal to roughly half the larger of those two measurements, then check the fit of a pinned mock-up.
| Blocked square width | Flat rectangle before trim | Folded side before trim |
|---|---|---|
| 14 cm | About 56 × 28 cm | About 28 × 28 cm |
| 15 cm | About 60 × 30 cm | About 30 × 30 cm |
| 16 cm | About 64 × 32 cm | About 32 × 32 cm |
These figures describe the layout before seam take-up. After blocking one square, make a paper rectangle four squares wide and two squares deep. Fold it as described below to check the proportions against your reference hood. If your first square is too small, add a granny round or reswatch with a larger hook. Use the same number of rounds on all eight squares.
Abbreviations and Pattern Notes
| Abbreviation | Meaning |
|---|---|
| ch | Chain |
| dc | Double crochet |
| sc | Single crochet |
| sl st | Slip stitch |
| ch-1 sp / ch-2 sp | Chain-1 space / chain-2 space |
| MR | Magic ring |
| Rnd / st | Round / stitch |
A granny group is 3 dc in one space. The beginning ch 3 counts as one dc. Work in joined rounds without turning. Change colors by fastening off at the end of the round and joining the next color in any corner.
Free Colorful Granny Square Crochet Hood Pattern
1. Crochet Eight Granny Squares
Rnd 1. With your first color, make an MR. Ch 3 and work 2 dc into the ring. Work [ch 2, 3 dc into the ring] three times. Ch 2 and join with a sl st to the top of the beginning ch 3. Pull the center closed. (4 groups and 4 corner spaces)
Rnds 2–6. Join the next color in a corner ch-2 sp. If continuing in the same color, sl st across the next two dc and into the first corner space. Work [ch 3, 2 dc, ch 2, 3 dc] in that space. Along the next side, work [ch 1, 3 dc in the next ch-1 sp] for each existing side space. In Rnd 2 there are no existing side spaces. Ch 1, then work [3 dc, ch 2, 3 dc] in the next corner. Repeat across the remaining sides. After the final ch 1, join to the top of the beginning ch 3 without remaking the starting corner.
| Rnd | Groups per side | Total dc |
|---|---|---|
| 1 | 1 | 12 |
| 2 | 2 | 24 |
| 3 | 3 | 36 |
| 4 | 4 | 48 |
| 5 | 5 | 60 |
| 6 | 6 | 72 |
For the multicolor look, alternate a bright color with a softer one. One sequence is turquoise, violet, cream, rose, red, and mustard. Change the sequence on neighboring squares so matching colors do not collect in one area.
Cream joining border. Join cream in any corner and ch 1. Work 3 sc in each corner, 1 sc in each dc, and 1 sc in every side ch-1 space. Join to the first sc. (104 sc after six granny rounds) Mark the middle sc of each corner. Weave in the ends and block all eight squares to the same width.
2. Lay Out and Join the Squares
| Edge | Left outer | Left inner | Right inner | Right outer |
|---|---|---|---|---|
| Face edge at the top | A | B | C | D |
| Back seam edge at the bottom | E | F | G | H |
Place the squares right sides up in the order shown. Join neighboring squares in each row with cream, then join the two rows along their long edges. Match the marked corner centers and pair the border stitches one for one. For a low-profile seam, whipstitch through the loop nearest the adjoining square on each piece. Keep the tension loose enough for the joined fabric to lie flat.
3. Fold the Hood and Sew the Back
- Keep the face edge at the top of your work. Fold the left half over the right half with right sides together, using the line between B and C and between F and G as the fold. B sits over C, A over D, F over G, and E over H.
- Along the original bottom edge only, pin the lower edge of F to G and the lower edge of E to H. Starting at the fold, whipstitch these paired edges to the outer corner. This seam runs down the back of the hood.
- Turn right side out. The original top edge across A, B, C, and D frames the face. The original far-left and far-right edges form the neckline. Try on the hood with the two lower front corners held together loosely under the chin. Check that the face edge and back seam sit where you want them before weaving in the seam tails.
4. Crochet the Cream Face Trim and Chin Ties
Trim. With the right side facing, join cream at one lower front corner. Ch 1 and sc along the face edge across A, B, C, and D. Continue around the neckline to the starting corner. Work one sc in each exposed border stitch, treating the matched corner stitches at panel joins as one position. At each lower front corner, work 3 sc in the marked corner-center stitch and mark the middle sc of the new corner. Join to the first sc.
For a thicker frame, work one more round in cream with one sc in each stitch and 3 sc in each marked corner stitch. If the neckline feels snug, stop after the first round or use a looser hook for the trim. Fasten off and weave in the ends.
Ties, make two. Chain to the length you want, then add one chain. For the first try-on, start with a chain about 25 cm long. Sc in the second ch from the hook and in each remaining ch. Make the second tie with the same chain count. Sew one tie to the inside of each lower front corner, passing the tail through several neighboring stitches so the attachment spreads across the trim. Try a loose bow and check the fit.
Troubleshooting
| If you notice | Try this |
|---|---|
| The squares are different sizes | Check the round and edge counts, then block the squares to the same measurements before joining. |
| The seams ridge or shorten the panel | Match the corner markers and keep the sewing yarn relaxed. Check the rectangle flat after each seam. |
| The back seam is on the wrong edge | Refold between B/C and F/G. Pair F with G and E with H along the original bottom edge. |
| The face border pulls inward | Rework the trim with relaxed tension. Check that you picked up stitches across the joins as well as the square edges. |
Variations and Care
Use muted shades with oatmeal seams for a quieter palette, or alternate two square color sequences for a more coordinated hood. Follow the yarn label for washing and dry the hood flat with the ties straightened. Reshape the face edge while the fabric is damp.
Frequently Asked Questions
Can I use granny squares I already have?
Yes. Choose eight that match in size and edge stitch count. Try the folded layout against a hood you own before joining them.
Can I make the hood shallower?
If the height fits but the back projects too far, the equal-sided layout may need changing. Use two rows of rectangles instead of squares and check the height and depth on a paper template before crocheting.
Can I leave off the ties?
Yes. Finish the face and neck opening with the cream trim and wear the hood loose.